Step4: click default button to resort default setting; click apply button to save the setting; click exit button to exit current interface.If you want to know more or withdraw your consent to all or some of the cookies, please refer to the cookie policy.By closing this banner, scrolling this page, clicking a link or continuing to browse otherwise, you agree to the use of cookies.
And ensure well ventilation around the machine Do not power off the DVR at normal recording condition The correct operation to shut off DVR is to stop recording firstly, and then select shut-down button at the right of the menu bar to exit, and finally to cut off the power. ![]() Xvim Setup Full Remote ControlMeanwhile, it utilizes many most advanced technologies, such as standard H.264 with low bit rate, Dual stream, SATA interface, VGA output mouse supported, IE browser supported with full remote control, mobile view(by phones), etc., which ensure its powerful. Please disconnect the power before being connected to other devices. Dont hot plug inout 2.1 Install Hard Drive DVD Writer 2.1.1 Install Hard Drive Notice: 1. This device is only for backup Step1: Unscrew and Open the top cover Step2: Connect the power and data cables. ![]() Enter backup mode in live Input number 10 and the above number together with other digital keys Digital button Input digitals or choose camera Enter button Confirm selection DirectionMulti-screen. Only video display, Spot out no menu show Audio out Audio output, connect to the sound box Connect to speed dome Connect to keyboard ALARM IN. Only video display, Spot out no menu show Audio out Audio output, connect to the sound box Video in Video input channels from 1-8 POWER INPUT. INFOR Button Get information about the DVR like firmware version, HDD information. When use of remote controller to control single DVR, its not necessarily to reset the device ID, user can do operation directly; when control multiple DVR with remote controller, please refer to below steps: Step1: Activate remote controller to control DVR: enable DVR: turn the IR sensor of the remote controller to the IR receiver that on the front panel, press the number key 8 twice, then input device ID (Range from: 0-65535. Change a mouse to try 2.5.2 Use Mouse The structure of the main menu is shown in Fig 2.9 Remote Controller. In live: Double-click left button on one camera to be full screen display. Click right button to show the control bar at the bottom of the screen as Fig 2.9 Remote Controller. Step3: disconnect the power 3.2 Login User can login and logout the DVR system. User cannot do any other operations except changing the multi-screen display once logout. The definitions for every parameters display as below: Device name: the name of the device. It may display on the client end or CMS that help user to recognize the device remotely. Note: after changed the language and video output, the device needs to login again. Time. Step3: click default button to resort default setting; click apply button to save the setting; click exit button to exit current interface. Live configuration Live configuration includes four submenus: live, host monitor, SPOT and mask. Step4: user can setup all channels with same parameters, tick off all, then do relevant setup. Delete mask area: select a certain mask area, click left mouse to delete that mask area, click Apply button to save the setting.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |